Turn signals help

[tileman]

I need to get some rear turn signals on my bike with bike week comeing up here in a few weeks.
And want to get something like the short stalks and keep the front runing light to.

What would you guys get that work good and hold up to dont want any junk.

I also have the Devil pipe on the rear so I will need to stay clear of that to.


Thanks for any info.


</p>

[GregGimbert]

What model bike is this for & does your tail light have one or two bulbs in it? Reason for questions is this, if rear taillight has 2 bulbs in it then you can use a turn signal integrator from a marine supply store. This will make your left or right taillight bulb flash as a blinker and still operate as a brake light too. You will see these priced fore $50 on ebay & bike sites but just go to Boater's World or better yet the marine surplus store on ISB near Bucks Gun Rack. You should find them near the trailer section for about $10. No advice for the front except that you will be able to keep the running lights even with aftermarket signals as long as you buy the ones designed for the front. I think they have a third wire for constant power(running light). hope this helps.

G

</p>

[tileman]

Sorry the bike is a 01 929 Eiron.

</p>

[DaveInDaytona]

The integrator thing works well if that's what you want to do. I had some short stalks on my other bike but with the tail kit I decided to go with the built in LED's with the addition of the integrator.

I used flush mounts on the front. With the curve of the cutout I had to do some custom work on them to make them fit right (I'm a bit picky at times) but it worked out well.

I'd be glad to show you what I did.

Dave

</p>